Table of Contents
Advertisement
The Intel® Intel® I210-IT Gigabit Ethernet controller provides one Gigabit Ethernet interface on the
front panel, GbE E.
The Gigabit Ethernet interfaces are implemented as three standard RJ-45 Ethernet connectors,
J10, J11 and J12 on the front panel.
2.7.5.1 10 Gigabit Ethernet Inter faces (CP6005X-SA)
The CP6005X-SA supports two 10GBASE-KR Ethernet interfaces on the rear I/O using the Intel®
82599ES dual-port 10 Gigabit Ethernet controller.
The following table indicates the 10 Gigabit Ethernet port mapping of the CP6005X-SA
Table 14: 10 Gigabit Ethernet Controller Port Mapping
ETHERNET CONTROLLER
Intel® 82599ES, port 0
Intel® 82599ES, port 1
2.7.6 SATA Inter faces
The CP6005(X)-SA provides six SATA ports:
»
One SATA 6 Gb/s port on the J16 connector for mounting either a SATA Flash module or an
onboard 2.5" HDD/SSD via the MMADP01-SATA01 module
»
One SATA 6 Gb/s port on the standard SATA connector, J14, for connection to SATA devices
via cable
»
Four SATA 3 Gb/s ports on the CompactPCI rear I/O interface
All six SATA interfaces provide high-performance RAID 0/1/5/10 functionality.
2.7.7 PMC Inter face
The CP6005(X)-SA provides one 3.3 V standard PMC interface with a dedicated 32-bit / 66 MHz PCI Ex-
press-to-PCI bridge. The PMC interface is compliant with the IEEE 1386.1-2001 specification, which de-
fines a PCI electrical interface for the CMC (Common Mezzanine Card) form factor.
A PMC module can be connected to the CP6005(X)-SA via the standard PMC connectors J20 (Jn1) and
J21 (Jn2).
Table 15: PMC PCI Frequency Configuration
FREQUENCY
33 MHz
33 MHz
66 MHz
www.kontron.com
High-speed ser ial rear I/O interconnection port 2 (10GBE2)
High-speed ser ial rear I/O interconnection port 1 (10GBE1)
M66EN Signal
DIP SWITCH SW2
J21 (Jn2)
SWITCH 3
Low
--
High
PORT MAPPING
OFF
ON
OFF
User Guide
CP6005(X)-SA
.
33
Advertisement
Table of Contents
