Table of Contents
Advertisement
10. 2 I P M I F i r mwa re a n d KC S I n te r f a c e C o n f i g u r a t i o n
Initially the default configuration of the IPMI firmware (KCS interface) is:
»
IRQ = 11
»
MODE = SMC
»
IPMB = single-ported.
If this is the required configuration, no further action is required. If the configuration must be modi-
fied, the kIpmi uEFI Shell command is used to modify the configuration as required, e.g. "kIpmi irq
[0|11]", "kIpmi mode [smc|bmc]", and "kIpmi ipmb [single-ported|dual-ported]". For information
on the kIpmi uEFI Shell command, refer to the uEFI BIOS Chapter.
The KCS interface serves for the communication between the CP6005(X)-SA's payload and the IPMI con-
troller. The IPMI OS kernel s require the KCS interface configuration during their loading time. The KCS
interface configuration is available in the "IPMI Device Information Record" included in the SMBIOS
table.
10. 3 S u p p o r te d I P M I a n d AT C A C o m m a n d s
10.3.1
Standard IPMI Commands
The following table shows an excerpt from the command list specified in the IPMI specification 2.0. The
shaded table cells indicate commands not supported by the CP6005(X)-SA IPMI firmware.
M = mandatory, O = optional
Table 62: Standard IPMI Commands
COMMAND
IPM DEVICE "GLOBAL" COMMANDS
Get Device ID
Cold Reset
Warm Reset
Get Self Test Results
Manufacturing Test On
Set ACPI Power State
Get ACPI Power State
Get Device GUID
Broadcast "Get Device ID"
BMC WATCHDOG TIMER COMMANDS
Reset Watchdog Timer
Set Watchdog Timer
Get Watchdog Timer
BMC DEVICE AND MESSAGING COMMANDS
Set BMC Global Enables
www.kontron.com
IPMI 2.0 SPEC.
NETFN
SECTION
20.1
App
20.2
App
20.3
App
20.4
App
20.5
App
20.6
App
20.7
App
20.8
App
20.9
App
27.5
App
27.6
App
27.7
App
22.1
App
User Guide
CP6005(X)-SA
CMD
KONTRON SUPPORT
ON IPMI CONTROLLER
M
01h
M / Yes
02h
O / Yes
03h
O / No
04h
O / Yes
05h
O / No
06h
O / Yes
07h
O / Yes
08h
O / No
01h
M / Yes
O
22h
O / Yes
24h
O / Yes
25h
O / Yes
O
2Eh
O / Yes
81
Advertisement
Table of Contents
