Serial Ports; Gigabit Ethernet; Dual Gigabit Ethernet Connector J11A/B - Kontron CP3002 User Manual

3u compactpci processor board based on the intel core i7 processor with the intel qm57 chipset
Table of Contents

Advertisement

CP3002
2.11.5

Serial Ports

The CP3002 provides two serial ports, COMA (3.3V LVTTL) available either on the 8HP version
or on the rear I/O, and COMB (3.3V LVTTL) available on the rear I/O.
COMA and COMB are fully compatible with the 16C550 controller and include a complete set
of handshaking and modem control signals. The COMA and COMB ports provide maskable in-
terrupt generation. The data transfer on the COM ports is up to 115.2 kbit/s.
2.11.6

Gigabit Ethernet

The CP3002 board includes two 10Base-T/100Base-
TX/1000Base-T Ethernet ports based on two Intel®
82574L Gigabit Ethernet controllers, which are connect-
ed to the x1 PCI Express interfaces of the QM57 chipset.
The Intel® 82574L Gigabit Ethernet Controller's archi-
tecture is optimized to deliver high performance with
the lowest power consumption. The controller's archi-
tecture includes independent transmit and receive
queues and a PCI Express interface that maximizes the
use of bursts for efficient bus usage.
The Boot-from-LAN and Wake-on-LAN features are
supported. Wake-on-LAN is available on all Ethernet interfaces. After an operating system
shutdown, a 1000Base-T Gigabit connection is automatically reduced to 100 Mbit or 10 Mbit
operation and the Ethernet controller waits to receive a broadcast or unicast packet with an ex-
plicit data pattern to assert a signal or a PME message to wake up the system. If the main pow-
er is switched off after an OS shutdown, a 5V standby supply must be provided over the J2 rear
I/O CompactPCI connector to continue powering the Wake-on-LAN relevant devices.
Note ...
The Ethernet transmission can operate effectively using a CAT5 cable with a
maximum length of 100 m.
The Ethernet connectors are realized as RJ-45 connectors. The interfaces provide automatic
detection and switching between 10Base-T, 100Base-TX and 1000Base-T data transmission
(Auto-Negotiation). Auto-wire switching for crossed cables is also supported (Auto-MDI/X).
ID 1042-9252, Rev. 2.0
Functional Description
Figure 2-3: Dual Gigabit Ethernet
Connector J11A/B
8
J11A
GbE A
1
8
J11B
GbE B
1
Page 2 - 13

Advertisement

Table of Contents
loading

Table of Contents