Table of Contents
Advertisement
2.3. ETHERNET INTERFACES
Both Ethernet controllers reside on the Primary PCI bus.
Each interface supports 10Base-T and 100Base-TX specifications: 10Mbps and 100Mbps
network speeds are automatically detected and switched.
Signal Path
See note on page 1.5.
Related Jumpers
None.
BIOS Settings
Section 4.1.11 Integrated Peripherals: Enable/Disable Ethernet Controller.
2.3.1 Front Plate Configuration
Ethernet 1 and 2 signals are available on front plate connectors only when the board is
ordered for front access.
Activity and link indicators are built in the connector.
2.3.2 cPCI I/O Configuration
Ethernet 1 and 2 signals are available on CPCI I/O connectors only when the board is ordered
for rear access.
CAUTION
The combination of both front and rear panel configurations is not supported.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
2-3
Onboard Features
Advertisement
Table of Contents
