Compactpci Rear I/O Connectors J3 And J5 Pinout - Kontron CP6005-SA User Manual

Table 20: 64-bit CompactPCI Bus Connector J2 Peripheral Slot Pinout
PIN Z
22 NC GA4
21 NC *
20 NC *
19 NC GND
18 NC RSV
17 NC RSV
16 NC RSV
15 NC RSV
14 NC *
13 NC *
12 NC *
11 NC *
10 NC *
9 NC *
8 NC *
7 NC *
6 NC *
5 NC *
4 NC V(I/O)
3 NC *
2 NC *
1 NC *
Note:
A * indicates that the signal normally present at this pin is disconnected from the Com-
pactPCI bus when the CP6005(X)-SA is inserted in a peripheral slot.

2.7.10.3 CompactPCI Rear I/O Connectors J3 and J5 Pinout

The CP6005(X)-SA board provides rear I/O connectivity for peripherals. Standard PC interfaces are im-
plemented and assigned to the front panel and to the rear I/O connectors J3 and J5.
When the rear I/O module is used, the signals of some of the main board/front panel connectors are
routed to the module interface. Thus, the rear I/O module makes it much easier to remove the CPU in
the rack as there is practically no cabling on the CPU board.
For the system rear I/O feature a special backplane is necessary. The CP6005(X)-SA with rear I/O is
compatible with all standard 6U CompactPCI passive backplanes with rear I/O support.
The CP6005(X)-SA conducts all standard rear I/O signals through the J3 and J5 connectors.
www.kontron.com
A B
GA3 GA2
GND RSV
GND RSV
GND IPMB2_SDA
RSV RSV
GND *
RSV DEG#
GND FAL#
* *
GND V(I/O)
* *
GND V(I/O)
* *
GND V(I/O)
* *
GND V(I/O)
* *
NC V(I/O)
RSV *
GND *
* SYSEN#
GND *
C D
GA1 GA0
RSV RSV
GND RSV
IPMB2_SCL IPMB2_Alert
GND RSV
* *
GND RSV
* *
GND *
* *
GND *
* *
GND *
* *
GND *
* *
GND *
* *
GND *
* *
* *
* *
User Guide
CP6005(X)-SA
E F
GND
GND
GND
GND
GND
GND
GND
GND
GND
GND
GND
GND
GND
GND
GND
GND
GND
GND
GND
GND
GND
GND
40