Advancedtca And Amc Commands - Kontron CP6005-SA User Manual

Table 62: Standard IPMI Commands (Continued)
COMMAND
Set Auxiliary Log Status
LAN DEVICE COMMANDS
Set LAN Conf iguration Parameters
Get LAN Conf iguration Parameters
Suspend BMC ARPs
Get IP/UDP/RMCP Statistics
SERIAL/MODEM DEVICE COMMANDS
SOL COMMANDS
SOL Activating
Set SOL Conf iguration Parameters
Get SOL Conf iguration Parameters
Note:
Some of the above-mentioned commands, such as SDR device commands, work only if the
IPMI controller is configured as BMC. For further information, refer to the IPMI specifica-
tion 2.0.
10.3.2 AdvancedTC A and AMC Commands
The following table shows an excerpt from the command list specified in the PICMG 3.0 R 2.0 Ad-
vancedTCA Base Specification and the PICMG AMC.0 Advanced Mezzanine Card Specification, R 1.0. The
shaded table cells indicate commands not supported by the IPMI firmware.
M = mandatory
Table 63: Standard IPMI Commands
COMMAND
AdvancedTCA
Get PICMG Proper ties
FRU Control
Get FRU LED Properties
Get LED Color Capabilities
Set FRU LED State
Get FRU LED State
Get Device Locator Record ID
www.kontron.com
IPMI 2.0 SPEC. NETFN
SECTION
40.13 Storage
23.1 Transpor t
23.2 Transpor t
23.3 Transpor t
23.4 Transpor t
25.1 to 25.12 Transpor t
26.1 Transpor t
26.2 Transpor t
26.3 Transpor t
IPMI 2.0 SPEC. NETFN
SECTION
3-9 PICMG
3-22 PICMG
3-29 PICMG
3-25 PICMG
3-26 PICMG
3-27 PICMG
3-29 PICMG
User Guide
CP6005(X)-SA
CMD KONTRON SUPPORT
ON IPMI CONTROLLER
5Bh O / No
O
01h O / Yes
02h O / Yes
03h O / No
04h O / Yes
10h to 1Bh O / No
0
20h O / Yes
21h O / Yes
22h O / Yes
CMD KONTRON SUPPORT
ON IPMI CONTROLLER
M
00h M / Yes
04h N/A
05h M / Yes
06h M / Yes
07h M / Yes
08h M / Yes
0Dh M / Yes
84