Standards; Additional Standards For Boards Ordered With Ruggedized Service - Kontron CP6005-SA User Manual

1. 5 St a n d a rd s
This product complies with the requirements of the following standards.
Table 2: Standards
T YPE
CE Emission
Immission
Electrical Safety
Mechanical Mechanical Dimensions
Environmental Climatic Humidity
WEEE
RoHS 2
In addition, boards ordered with the ruggedized service comply with the following standards as well.
Table 3: Additional Standards for Boards Ordered with Ruggedized Service
T YPE
Environmental Vibration
(Sinusoidal)
Single Shock
Permanent Shock
Note:
Customers desiring to perform further environmental testing of the CP6005(X)-SA must
contact Kontron for assistance prior to performing any such testing.
Boards without conformal coating must not be exposed to a change of temperature which
can lead to condensation. Condensation may cause irreversible damage, especially when
the board is powered up again.
Kontron does not accept any responsibility for damage to products resulting from destruc-
tive environmental testing.
www.kontron.com
ASPECT
ASPECT STANDARD
IEC60068-2-6
IEC60068-2-27
IEC60068-2-29
STANDARD
EN55022, EN61000-6-3
EN55024, EN61000-6-2
EN60950-1
IEEE 1101.10
IEC60068-2-78 (see note below)
Directive 2002/96/EC
Waste electr ical and electronic equipment
Directive 2011/65/EU
Restriction of the use of cer tain hazardous sub-
stances in electr ical and electronic equipment
REMARKS
Ruggedized version test parameters:
10-300 (Hz) frequency range
2 (g) acceleration
1 (oct/min) sweep rate
10 cycles/axis
3 axes
Ruggedized version test parameters:
30 (g) acceleration
9 (ms) shock duration half sine
3 number of shocks per direction (total: 18)
6 directions
5 (s) recovery time
Ruggedized version test parameters:
15 (g) acceleration
11 (ms) shock duration half sine
500 number of shocks per direction
6 directions
5 (s) recovery time
User Guide
CP6005(X)-SA
23