Serial Ports; Gigabit Ethernet; Gigabit Ethernet Controller Port Mapping; Serial Port Connector J8 - Kontron CP6005-SA User Manual

6u compactpci processor board
Table of Contents

Advertisement

2.7.4 Ser ial Por ts
The CP6005(X)-SA provides two serial ports:
»
COMA (RS-232) available either on the front panel or on the CompactPCI rear I/O interface
»
COMB (RS-232) on the CompactPCI rear I/O interface
COMA and COMB are fully compatible with the 16550 controller. The rear I/O COMA port includes a com-
plete set of handshaking and modem control signals. The COMB port includes RXD, TXD, CTS, and RTS
signals.
The COMA and COMB ports provide maskable interrupt generation. The data transfer on the COM ports
is up to 115.2 kbit/s. If RS-422 is required on the COMB port, please contact Kontron for further assis-
tance.
The serial port COMA is implemented as an 8-pin RJ-45 connector, J8. The following figure and table
provide pinout information for the serial connector J8 (COMA).
Figure 6: Serial Port Connector J8
1
8

2.7.5 Gigabit Ethernet

The CP6005(X)-SA board provides five 10Base-T/100Base-TX/1000Base-T Ethernet interfaces. They are
based on one Intel® I350 quad-port Gigabit Ethernet controller and one Intel® I210-IT Gigabit Ether-
net controller.
The Intel® I350 quad-port Gigabit Ethernet controller provides four Gigabit Ethernet interfaces, two on
the front panel, GbE A and GbE B, and two on the rear I/O, PICMG 2.16 LPa and PICMG 2.16 LPb. All four
Ethernet channels support IPMI over LAN (IOL) and Serial over LAN (SOL).
Table 13: Gigabit Ethernet Controller Port Mapping
ETHERNET CONTROLLER
Intel® I350, por t 0
Intel® I350, por t 1
Intel® I350, por t 2
Intel® I350, por t 3
Intel® Intel® I210-IT
www.kontron.com
Table 12: Serial Port Connector J8 Pinout
PIN
SIGNAL
1
RTS
2
DTR
3
TXD
4
GND
5
GND
6
RXD
7
DSR
8
CTS
PORT MAPPING
Rear I/O por t PICMG 2.16 LPb
Rear I/O por t PICMG 2.16 LPa
Front I/O connector J11 (GbE B)
Front I/O connector J10 (GbE A)
Front I/O connector J12 (GbE E)
User Guide
CP6005(X)-SA
DESCRIPTION
Request to send
Data terminal ready
Transmit data
Signal ground
Signal ground
Receive data
Data send request
Clear to send
IOL/SOL Channel (IPMI)
2
3
4
5
--
I/O
O
O
O
--
--
I
I
I
32

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cp6005x-sa

Table of Contents