Table of Contents
Advertisement
10.5.3 Set Control State (SPI Boot Flash Selection, Boot Order Selection)
Table 65: Set Control State
COMMAND
Set Control State (SPI Boot Flash, Boot Order)
Byte
Data Field
1
Control ID:
00h = SPI boot flash selection
9Dh = uEFI BIOS boot order conf iguration
Control state for SPI boot flash selection (00h):
2
00h = Standard SPI boot flash is selected (default)
01h = Recover y SPI boot flash is selected
Note:
The DIP switch SW1, switch 2, may overwr ite the above selection.
Control state for uEFI BIOS boot order configuration (9Dh):
00h = Boot order is according to uEFI BIOS setup (default)
01h = Next boot device is: Floppy
02h = Next boot device is: HDD
03h = Next boot device is: CD
04h = Next boot device is: Network
05h = Next boot device is: USB Floppy
06h = Next boot device is: USB HDD
07h = Next boot device is: USB CD-ROM
Byte
Data Field
1
Completion code
Note:
The settings mentioned above are stored in EEPROM and applied (to logic) each time the
IPMI controller detects power-on.
www.kontron.com
LUN
00h
REQUEST DATA
RESPONSE DATA
User Guide
CP6005(X)-SA
NetFn
CMD
OEM = 3Eh
20h
87
Advertisement
Table of Contents
