Table of Contents
Advertisement
Enter the sample start-up script mentioned above in this section using the edit uEFI Shell
3.
command.
myramdisk:\> edit boot.nsh
4.
Save the start-up script to the SPI boot flash using the kBootScript uEFI Shell command.
myramdisk:\> kbootscript -p boot.nsh
Reset the board to execute the newly installed script using the reset uEFI Shell command.
5.
myramdisk:\> reset
If a script is already installed, it can be edited using the following kBootScript uEFI Shell
6.
commands.
myramdisk:\> kbootscript -g boot.nsh
myramdisk:\> edit boot.nsh
9 . 5 F i r mwa re Up d a t e
Firmware updates are typically delivered as a ZIP archive containing only the firmware images. The con-
tent of the archive with the directory structure must be copied on a data storage device with FAT par-
tition. If the command kBoardConfig AutoUpdate has been enabled, the images are automatically
detected during boot-up and an update of the uEFI BIOS or the IPMI firmware is carried out.
9.5.1 Updating the uEFI BIOS
9.5.1.1 uEFI BIOS Fail-Over Mechanism
The CP6005(X)-SA has two SPI boot flashes programmed with the uEFI BIOS, a standard SPI boot flash
and a recovery SPI boot flash. The basic idea behind that is to always have at least one working uEFI
BIOS flash available regardless if there have been any flashing errors or not.
9.5.1.2 Updating Procedure
The standard SPI boot flash can be updated with the latest uEFI BIOS from the ZIP archive using the
kUpdate -u or the kFlash -p uEFI Shell command. When using the kUpdate command, the directory
structure of ZIP archive must not be altered. The update status is indicated in the log file located in the
directory where the firmware images are stored.
www.kontron.com
User Guide
CP6005(X)-SA
78
Advertisement
Table of Contents
