Operating In The Cw Mode - Icom IC-7200 Advanced Instructions

Previous view
4
RECEIVE AND TRANSMIT

■ Operating in the CW mode

Connect a paddle, straight key or external electron-
q
ic keyer as described on page 2-8.
Hold down F-INP ENT
w
band key to select the desired band.
Push to select the CW mode.
e MODE
MODE
• Hold down
CW and CW-R modes.
Rotate [DIAL] to tune in a desired signal.
r
• The S-meter displays the received signal strength when
a signal is received.
[AF] control to set the audio to a com-
Rotate the
t
fortable listening level.
Set CW break-in mode and the CW delay time in
y
the Set mode.
q Hold down
the Set mode.
w Rotate [M-CH] to select "BK-IN" to set the CW
break-in mode.
e Rotate [DIAL] to select full break-in, semi
break-in or OFF.
• FL : full break-in
• SE : semi break-in
• OF : break-in OFF
r Rotate [M-CH] to select "BK-DELAY" to se-
lect the CW delay time when the semi break-in
mode is selected in step e.
t Rotate [DIAL] to set the desired delay time.
y Continue to set the keyer settings in the Set
mode, if necessary. (p. 10-15)
u Push M-CH/RIT
SET
Key to transmit, using the paddle, straight key or
u
external electronic keyer to send your CW signals.
• " " appears.
• The Po meter displays the transmit output power.
Stop keying to receive.
i
for 1 second, then push a
BAND
for 1 second to toggle between the
M-CH/RIT
for 1 second twice to enter
SET
to exit the Set mode.
"CW" or "CW-R" appears.
Set mode
Semi break-in (default: OFF)
7.5 dots (default)
Appears when semi break-in is selected.
Appears while transmitting.
[AF]
"CW" or "CW-R" appears.
4-5
Band keys
[DIAL] [M-CH]