About The Memory Channels; Selecting Memory Channels - Icom IC-7200 Advanced Instructions

Previous view
7
MEMORY OPERATION

■ About the Memory channels

The transceiver has 201 memory channels, including
2 scan edge channels.
The Memory mode is very useful to quickly select of-
ten-used frequencies.
All 201 memory channels are tuneable, which means
the programmed frequency can be tuned temporarily
by rotating [DIAL], even in the memory mode.
MEMORY
CHANNEL
Regular memory
channels
Scan edge
memory channels

■ Selecting Memory channels

V/M
Push to select the Memory mode.
q
• " " appears.
[M-CH] to select the desired memory chan-
Rotate
w
nel.
• If the RIT control indicator lights orange, push
to turn OFF the RIT and set the [M-CH] control to
memory channel control. (See details below.)
• All memory channels, including blank channels, can be
selected.
• Pushing [UP]/[DN] on the microphone also selects the
memory channels. Only programmed memory chan-
nels are selectable using the microphone buttons.
About the [M-CH] control:
When the RIT control indicator lights orange, the
memory channels cannot be selected by rotating
the [M-CH] control because the [M-CH] control
acts as the RIT control.
In this case, push
trol to memory channel control (RIT control indica-
tor goes out).
Lower channels
MEMORY
CHANNEL
NUMBER
Independent transmit and receive frequencies
1–199
and mode in each memory channel.
One frequency and mode in each memory chan-
P1, P2
nel to use as scan edges for a programmed
scan.
M-CH/RIT
to set the [M-CH] con-
SET
RIT control indicator
goes out
Higher channels
CAPABILITY
[EXAMPLE]: Selecting memory channel 17.
[EXAMPLE]: Selecting memory channel 17.
VFO mode
[EXAMPLE]: Selecting memory channel 17.
VFO mode
M-CH/RIT
VFO mode
SET
Memory mode
Memory mode
Memory mode
7-2
COPY OVER-
TO VFO WRITING
Yes Yes
Yes Yes
V/M
Push
Rotate [M-CH]
Channel 17 is selected.
Channel 17 is selected.
Channel 17 is selected.
CLEAR
Yes
No
RIT control
indicator
[M-CH]