D Adjusting The Cw Side Tone; D Setting Keying Speed - Icom IC-7200 Advanced Instructions

Previous view
4
RECEIVE AND TRANSMIT
Operating in the CW mode (Continued)
■

D Adjusting the CW side tone

When the transceiver is in receive, and the break-in
function is OFF, you can listen to the tone of your CW
signal without actually transmitting. (pp. 6-4, 6-5)
You can also use the CW sidetone to practice CW
sending, but be sure to turn OFF the Break-in func-
tion.
q When the CW or CW-R mode is selected, hold down
M-CH/RIT for 1 second to enter the Quick Set mode.
SET
Rotate [M-CH] to select "SIDE LVL", then rotate
w
[DIAL] to adjust the side tone level.
• Adjust the side tone level to between 0% and 100%, in
1% steps.
M-CH/RIT
Push
e
SET

D Setting Keying speed

The transceiver's internal electronic keyer speed can
be set to between 6 and 60 words per minute (wpm).
q When the CW or CW-R mode is selected, hold down
M-CH/RIT for 1 second to enter the Quick Set mode.
SET
Rotate [M-CH] to select "KEY SPD", then rotate
w
[DIAL] to set the keying speed.
M-CH/RIT
Push
e
SET
to exit the Quick Set mode.
to exit the Quick Set mode.
4-9
[DIAL] [M-CH]
[DIAL] [M-CH]