Microphones - Icom IC-7200 Advanced Instructions

Previous view
1
PANEL DESCRIPTION

■ Microphones

D SM-50
(Option)
q
D SM-30
(Option)
TOP VIEW
q
BOTTOM VIEW
D HM-36
e
q
r
e
w
y
w
t
y r
OFF ON
MIC GAIN LOW CUT
q PTT SWITCH
Hold down to transmit; release to receive.
w PTT LOCK SWITCH
(Only for the SM-50 and SM-30)
Push to lock the PTT switch in the transmit mode.
e UP/DOWN SWITCHES [UP]/[DN]
Change the selected readout frequency or memory
channel.
• Holding down continuously changes the frequency or
memory channel number.
• While holding down
cy can be controlled while in the split frequency mode.
* Only when the XFC (transmit frequency check) func-
tion is ON. (p. 10-11)
• The [UP]/[DN] switch can simulate a key paddle. Pre-
set in the Set mode (U/D KEY; Mic Up/Down Keyer).
(p. 10-15)
r LOW CUT SWITCH
(Only for the SM-50 and SM-30)
Push (SM-50)/Slide (SM-30) to cut out the low fre-
quency components of input voice signals.
t PTT LOCK INDICATOR [LOCK]
(Only for the SM-30)
Lights red when the PTT lock switch (e) is ON.
y MIC GAIN VOLUME [MIC GAIN]
(Only for the SM-50 and SM-30)
Rotate to adjust the microphone output level.
• Use this control as an addition to the microphone gain
setting of the connected transceiver.
Rotating the control too far clockwise may result
in an output level that is too high and transmit
signal distortion.
1-17
*, the transmit readout frequen-
RIT