Icom IC-7200 Advanced Instructions page 108

Previous view
10
SET MODE
Items in the Set mode (Continued)
■
XFC
Turn the XFC (transmit frequency check) function ON
or OFF.
on : The transmit frequency can be monitored while
holding down
oF : The transmit frequency check function is OFF.
NOTE: When the XFC function is ON, the RIT cal-
culation function is disabled. (p. 5-2)
Auto Tune
Turns the Auto tune function ON or OFF. The AT-180
antenna tuner has an automatic start capability which
starts tuning if the SWR is higher than 1.5:1.
on : The automatic tune starts even when the tuner
is turned OFF during HF band operation.
oF : The tuner remains OFF even when the SWR is
poor (1.5:1).
PTT Tune
Turns the PTT Tune function ON or OFF. Tuning of the
antenna tuner can be automatically started at the mo-
ment [PTT] is pushed after the operating frequency is
changed more than 1% from the last-tuned frequency.
When an AT-180 antenna tuner is connected, the
tuner function must be turned ON first.
on : Tuning starts when [PTT] is pushed on a new
frequency.
oF : Tuning starts only when
Modulation input (Data OFF)
Selects the desired connector(s) for modulation input
when the SSB data/AM data mode is not in use.
M (MIC)
A (ACC)
M A (MIC/ACC) : Use the signals from [MIC] and
U (USB)
Modulation input (Data ON)
Selects the desired connector(s) for modulation input
when the SSB data/AM data mode is in use.
M (MIC)
A (ACC)
M A (MIC/ACC) : Use the signals from [MIC] and
U (USB)
.
RIT
is pushed.
TUNER
: Use the signals from [MIC].
: Use the signals from [ACC] (pin11).
[ACC] (pin11).
: Use the signals from [USB].
: Use the signals from [MIC].
: Use the signals from [ACC] (pin11).
[ACC] (pin11).
: Use the signals from [USB].
MIC/ACC (default)
10-11
OFF (default)
OFF (default)
OFF (default)
ACC (default)