D Selecting The Auto Tuning Step; D Using The ¼ Tuning Function - Icom IC-7200 Advanced Instructions

Previous view
3
BASIC OPERATION
Frequency setting (Continued)
■

D Selecting the Auto tuning step

When rotating the tuning dial rapidly, the tuning speed
accelerates automatically if selected.
M-CH/RIT
Hold down
q
Set mode.
Rotate [M-CH] to select "AUTo TS."
w
[DIAL] to select the desired tuning speed
Rotate
e
between HI (High), Lo (Low) and oF (OFF).
• HI : Approximately 5 times faster when the tuning step
is set to 1 kHz or smaller steps; approximately 2
times faster when the tuning step is set to 5 kHz or
larger steps.
• Lo: Approximately 2 times faster
• oF: Auto tuning step is turned OFF
• Hold down
M-CL
or value.
M-CH/RIT
Push
r
SET
D Using the ¼ tuning function (SSB data/CW/RTTY only)
While operating in SSB data/CW/RTTY, the ¼ tuning
function can be used for critical tuning. Dial sensitivity
is reduced to ¼ of normal when the ¼ function is in
use.
M-CH/RIT
Hold down
q
Set mode.
[M-CH] to select "DIAL ¼."
Rotate
w
[DIAL] to select the ¼ tuning function ON
Rotate
e
or OFF.
• Hold down
M-CL
or value.
M-CH/RIT
Push
r
SET
NOTE: This function is only selectable when the
Quick tuning function is OFF. (p. 3-7)
for 1 second twice to enter the
SET
for 1 second to select a default option
to exit the Set mode.
for 1 second twice to enter the
SET
for 1 second to select a default option
to exit the Set mode.
When "HI" is selected (default)
When "OFF" is selected (default)
3-9
[DIAL] [M-CH]
[DIAL] [M-CH]