Table of Contents
Advertisement
Chapter 14: Software installation, upgrade, and update procedures 397
Procedure 2: Start the update process
This procedure describes how to begin the update process. If you intend to
back up your configuration files and data files, ensure that you have a blank
write-enabled tape available before you start this procedure. If you do not
intend to back up your configuration files and data files, start at step 4.
1
Log in as maint. The default password is maint.
2
Use the backdata command to back up all configuration files and
data files (see Procedure 11: Back up configuration files and data
files).
3
Type install and press [Return].
Figure 115
Install command prompt
You can reconfigure the system using a keycode without a tape or you can use a
tape to upgrade the software and reconfigure. Do you want to use a tape (y/n/q)?
4
You are prompted to use a tape (Figure 115). Type y and press
[Return].
Figure 116
Drive selection menu
Select which drive to use:
1
ctape
Enter a number, a name, the initial part of a name, or
? for HELP,
5
At the drive selection menu, type 1 and press [Return] to select the
cassette tape drive.
The message shown in Figure 117 appears.
Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide
2
diskette1
q to QUIT:
3
hddiskette1
Hide quick links:
Advertisement
Table of Contents
