Procedure 7: Reboot And Go Through Setup - Meridian Link/Customer Controlled Routing Installation And Upgrade Manual

448 Chapter 14: Software installation, upgrade, and update procedures

Procedure 7: Reboot and go through setup

553-3202-210 Standard October 1998
If you have just installed the operating system tape, ensure that you perform
the following procedure before you load the application tape.
Note: If you are upgrading Meridian Link to co-residency and your
Application Module needs an MVME332 ACC card, ensure that you
have installed the ACC card before starting this procedure (refer to
Procedure 29: Installing MVME332XT or MVME332XTS ACC card,
in Chapter 17, ÒHardware upgradeÓ).
1 Press the red RESET button on the MVME147 or MVME167 SBC
card or the IPE Module.
System start-up messages appear on the system console (see
Figures 202 and 203).
Figure 202
MVME147 Application Module start-up messages
Copyright Motorola Inc. 1989,1990, All Rights Reserved
VME147 Monitor/Debugger Release 2.42 - 08/01/91
CPU running at 25 MHz
FPC passed test
MMU passed test
COLD Start
Onboard RAM start = $00000000,
No offboard RAM detected
Figure 203
IPE Module or MVME167 Application Module start-up messages
Copyright Motorola Inc. 1988 - 1992, All Rights Reserved
MVME167 Debugger/Diagnostics Release Version 1.4 - 07/22/92
COLD Start
Local Memory Found =00800000 (&8388608)
MPU Clock Speed =25Mhz
stop = $007FFFFF