Table of Contents
Advertisement
8
Slide the Application Module back into place and tighten the four
screws.
9
Connect the NT7D47EA cable to the Ethernet port on the generic I/O
panel. This cable will be connected to an Ethernet transceiver. For
more information, refer to ÒInstalling Ethernet LAN supportÓ in
Chapter 9, ÒMeridian Link/CCR interface cabling.Ó
Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide
Chapter 17: Hardware upgrade 525
Hide quick links:
Advertisement
Table of Contents
