Table of Contents
Advertisement
476 Chapter 14: Software installation, upgrade, and update procedures
Procedure 11: Back up configuration files and data files
553-3202-210 Standard October 1998
1
At the ÒConsole Login:Ó prompt, type maint (if you are not already
logged in) and press [Return]. The default password is maint.
2
Insert the backup tape into the drive.
Ensure that the tape is a backup tape and not a system tape,
because any information on the tape will be overwritten by the
backup. Ensure that the tape is not write-protected.
Note: Ensure you use the correct backup tape. An IPE Module uses a
600-Mbyte tape. An Application Module uses a 155-Mbyte tape.
3
At the Òmaint>Ó prompt, type backdata and press [Return] to start
the backup process.
Figure 257
Backdata messages 1
Files will be backed-up from:
/usr/maint/files/AMprofile
/usr/maint/files/AutoStart
/usr/maint/files/IncrDY
/usr/maint/files/IncrTM
/usr/maint/files/Port
/usr/maint/files/Prefs
/usr/maint/files/Speed
.
.
.
(Actual list of directories may differ depending on the application)
Make sure tape is in drive
When ready, enter ÔyÕ to continue, or ÔnÕ to quit:
4
You are prompted to continue the backup process. Wait until the
tape LED goes off before typing y and pressing Return.
Various messages appear; the backup is complete when the
message ÒBackup successfulÓ appears.
[y,n]
Hide quick links:
Advertisement
Table of Contents
