Backplane Cable Rerouting For Nt8D37 Ipe Module - Meridian Link/Customer Controlled Routing Installation And Upgrade Manual

Backplane cable rerouting for NT8D37 IPE Module

In the standard 12-cable configuration for the backplane in the NT8D37 IPE
Module, cables D, H, N, and U are not used. Those cables are used in the
16-cable fully expanded configuration.
Note: Backplane slots 0, 4, 8, and 12 (for cables A, E, K, and R) are
already fully cabled for 24 pairs, so no change is required for those
slots.
Table 67 lists cable connections before cable expansion. Figure 52 shows
the backplane slots before cable expansion.
Table 67
NT8D37 cable connections (standard configuration)
I/O panel connector
Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide
Chapter 9: Meridian Link/CCR interface cabling 195
Backplane cable
port
A
B
C
E
F
ÑcontinuedÑ
connector
A-1
A-2
A-3
B-1
B-2
B-3
C-1
C-2
C-3
E-1
E-2
E-3
F-1
F-2
F-3
Backplane slot
position
L0-1
L0-2
L0-3
L1-1
L1-2
L2-1
L2-2
L3-1
L3-2
L4-1
L4-2
L4-3
L5-1
L5-2
L6-1