Procedure 12: Verifying The Link Status - Meridian Link/Customer Controlled Routing Installation And Upgrade Manual

Procedure 12: Verifying the link status

1 Log in as mlusr (if you are not already logged in). The default
password is mlusr.
2 Type status link 0 and press [Return] to verify the status of the link
to Meridian 1.
The response ÒLink 0: UpÓ indicates that the link is functioning
properly. If you receive a different response, refer to the Application
Module and Intelligent Peripheral Equipment Module Diagnostic and
Maintenance Guide (NTP 553-3211-510).
3 Meridian Link only
Type status link 1 and press [Return] to verify the status of the link
to the host computer.
The response
properly. This message appears only if a host application is
connected. If you receive a different response, refer to the
Application Module and Intelligent Peripheral Equipment Module
Diagnostic and Maintenance Guide (NTP 553-3211-510).
4 Meridian Link only
Type status link 2 and press [Return] to verify the status of the link
to the host computer.
The response ÒLink 2: UpÓ indicates that the link is functioning
properly. This message appears only if a host application is
connected. If you receive a different response, refer to the
Application Module and Intelligent Peripheral Equipment Module
Diagnostic and Maintenance Guide (NTP 553-3211-510).
Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide
Chapter 15: Link configuration 483
Link 1: UpÓ indicates that the link is functioning
Ò