Meridian Link/Customer Controlled Routing Installation And Upgrade Manual page 512

494 Chapter 15: Link configuration
Table 142
X.25 and LAPB parametersÑLink 1 (continued)
Link parameter
Lowest LCN*
Highest LCN*
LOC LIC*
HOC HIC*
T10
T11
Note: Parameters marked with an asterisk (*) cannot be changed.
553-3202-210 Standard October 1998
Procedure 14: Changing Meridian Link (link 1) parameters (continued)
Allowed values
(defaults in parentheses)
(1)
(4095)
(-1)
(-1)
0Ð(1800)Ð9999
0Ð(2000)Ð9999
Specifies the lowest X.25 virtual
circuit number that will be assigned
for an incoming or outgoing X.25 call
request. Default value is 1.
Specifies the highest X.25 virtual
circuit number that will be assigned
for an incoming or outgoing X.25 call
request. Default value is 4095.
Specifies the lowest X.25 virtual
circuit number that will be assigned
for an incoming (if DCE) or outgoing
(if DTE) X.25 call request. Not used
by the AM. Default value is Ð1.
Specifies the highest X.25 virtual
circuit number that will be assigned
for an incoming (if DCE) or outgoing
(if DTE) X.25 call request. Not used
by the AM. Default value is Ð1.
Amount of time (in 1/10 second
increments) the AM will wait for an
X.25 restart confirmation packet
after sending an X.25 restart packet
to the host.
Amount of time (in 1/10 second
increments) the host will wait for an
X.25 call accept packet after
sending an X.25 call request packet
to the AM.
Ñ continued Ñ
Description