Meridian Link/Customer Controlled Routing Installation And Upgrade Manual page 16

xvi About this guide
Chapter 3: Overview of Customer Controlled Routing
provides an overview of CCR, describes its concepts, and lists required
hardware and software.
Chapter 4: Meridian Link/CCR hardware
overview of hardware components.
Chapter 5: Hardware installation overview
provides tables to describe the installation of an IPE Module or an
Application Module.
Chapter 6: Site survey/installation checklist
checklist to ensure that all hardware and software requirements are met for a
successful installation.
Chapter 7: Unpack and inspect hardware
information on receiving, unpacking, and inspecting the IPE Module and
Application Module hardware components.
Chapter 8: Hardware installation procedures
the main hardware installation procedures, with references to surrounding
chapters for further information.
Chapter 9: Meridian Link/CCR interface cabling
the cabling requirements. Two following chapters describe how to set up
terminals, and how to configure the Meridian 1 system.
Chapter 10: Installing peripheral devices
procedures for how to set up and configure video display terminals and
printers supported by the Meridian Link and CCR appplications.
Chapter 11: Peripheral device cabling interface
information on installing and configuring modems and the A/B switchbox.
Chapter 12: Meridian 1 configuration for Meridian Link/CCR
chapter shows how to use various software programs to configure the
Meridian 1 to support Meridian Link and CCR.
553-3202-210 Standard October 1998
Note: If you intend to install an IPE Module or an Application
Module, refer to Table 11 (IPE Module) or Table 12 (Application
Module) in this chapter.
This chapter
This chapter provides an
This chapter lists the tools and
This chapter provides a
This chapter provides
This chapter contains all of
This chapter describes
This chapter describes the
This chapter provides
This