Configure Sdi Port For Conshare (X11 Release 18 Or Later) - Meridian Link/Customer Controlled Routing Installation And Upgrade Manual

Configure SDI port for conshare (X11 Release 18 or later)

Table 112
LD 17ÑConfigure SDI port (X11 Release 18 or later)
Chapter 12: Meridian 1 configuration for Meridian Link/CCR 317
The SDI port is used for the optional console sharing feature, which allows
the IPE Module or the Application Module console to access Meridian 1
administration and maintenance programs. Port settings on the card should
reflect TTY mode at 2400 baud. Define the SDI port and its characteristics
by responding to the following prompts in LD 17.
Prompt Response
REQ CHG
TYPE CFN
ADAN NEW TTY x
CTYP SDI
SDI2
SDI4
XSDI
DNUM 0Ð15
USER aaa aaa
CDR
BUG
CSC
CTY
MTC
NOO
SCH
TRF
XSM YES, (NO)
ADAN <cr>
Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide
Comment
Create or change information in the database
Configuration record data block
Add SDI on port x (0Ð15) for console sharing
Single port SDI card
Dual port SDI card
Four port SDI card
SDI Paddle Board
Device number (same as ADAN number)
Enter one or more of the following terminal
functions:
CDR data link
BUG error messages on this port
Automatic Set Relocation and Attendant
Administration messages
CDR TTY port
Allow maintenance overlays
No overlay allowed
Allow service change overlays
Traffic reports
SDI port for the System Monitor
Go to next prompt