Configuring Dnis To Use Auto-Terminating Trunks; Ld 15Ñcustomer Data Block - Meridian Link/Customer Controlled Routing Installation And Upgrade Manual

Configuring DNIS to use auto-terminating trunks

LD 15ÑCustomer data block
Table 114
LD 15ÑEnable DNIS
Chapter 12: Meridian 1 configuration for Meridian Link/CCR 319
Dialed Number Identification Service (DNIS) is an optional feature that
provides the last digits of the dialed number. DNIS is defined by responding
to specific prompts in LD 15, LD 16, and LD 14. This section describes
how you can configure DNIS to use auto-terminating trunks. You can
alternatively configure DNIS to use Incoming Digit Conversion (IDC); refer
to ÒConfiguring DNIS to use Incoming Digit ConversionÓ later in this
chapter.
Note: Meridian Link 5C and CCR Release 3C support up to 31 DNIS
digits. X11 Release 24 is required for this feature. Prior to X11 Release
24, only seven digits were supported.
The DNIS option must be enabled in LD 15.
Prompt Response
REQ CHG
TYPE AML_DATA
CUST 0Ð99
OPT DNI
¥
¥
¥
REQ CHG, END
Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide
Comment
Create or change data in the database
Change Application Module Link options
Customer number
DNIS for this customer
Press [Return] until the REQ prompt
appears
Either change more customer data or exit
the overlay