Meridian Link/Customer Controlled Routing Installation And Upgrade Manual page 437

Chapter 14: Software installation, upgrade, and update procedures 419
Procedure 5: Load the operating system tape on an Application Module
with an MVME147 card (continued)
15 When the tape indicator goes off, type 2 and press [Return].
16 You are prompted to enter the alternate boot device. Type 4, and
press [Return].
17 When the start-up interrupt menu reappears, type 1 and press
[Return] to continue the system start-up.
The system starts up. A series of test messages will appear on one
line across the screen for approximately ten minutes. The system
start-up messages begin to appear as shown in the following figure.
Figure 154
System start-up messages
Testing Complete
Autoboot in progress ... To abort hit <BREAK>
RAM address from VMEbus = $00000000
Booting from: VME147, Controller 4, Device 0
Loading: Operating System
Volume: V/68
IPL loaded at: $001F0000
MVMETAPE IPL Version 1.0
***********************************************************************
System V/68 Release R3V7 M68030 Version 920526
***********************************************************************
Copyright (c) 1984-1992 Motorola Inc. All rights reserved
INIT: SINGLE USER MODE
***
erase = # kill = @
***
147 SCSI configuration
Device Addr Vers Revision
------- ---- ---- --------
Disk 00 0001
Tape 40 0001
Enter the correct date and time EST using one of the following formats
[mmddhhmmyy] or [mmddhhmmyyyy]:
18 Type the date in the form MMDDHHMMYY (month, date, hour in
24-hour clock format, minute, yearÑnote that the time should be in
Eastern Standard Time), or MMDDHHMMYYYY, and press [Return].
Example: 0314163098 or 031416301998
Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide
Real mem = 6291456
Avail mem = 4964352
Buffers = 60
intr = DEL quit = ^|
Seria Blocks
------- -------
M606... ....... 0352175
RV F... ....... 0000000
Size Vendor Description
---- ------------------------
0512 FUJITSU M2614S
0000 TEAC MT-2ST/N50