Meridian Link/Customer Controlled Routing Installation And Upgrade Manual page 208

190 Chapter 9: Meridian Link/CCR interface cabling
553-3202-210 Standard October 1998
8 Move cable end H-3 from slot position L8-1 to slot position L7-3.
9 Remove cable K from the backplane and connect cable ends K-1,
K-2, and K-3 to slot positions L8-1, L8-2, and L8-3.
10 Add cable L to the I/O panel by connecting cable ends L-1, L-2, and
L-3 to slot positions L9-1, L9-2, and L9-3.
The backplane cabling should now be as shown in Table 65 and Figure 50.
All slots are now ready to receive an IPE Module.
Table 65 lists cable connections for a fully expanded configuration.
Figure 50 shows the backplane slots in a fully expanded configuration.
Table 65
NT8D11 cable connections (fully expanded configuration)
I/O panel connector
port
A
B
C
D (new cable)
E
F
Backplane cable
connector
A-1
A-2
A-3
B-1
B-2
B-3
C-1
C-2
C-3
D-1
D-2
D-3
E-1
E-2
E-3
F-1
F-2
F-3
Ñ continued Ñ
Backplane slot
position
L0-1
L0-2
L0-3
L1-1
L1-2
L1-3
L2-1
L2-2
L2-3
L3-1
L3-2
L3-3
L4-1
L4-2
L4-3
L5-1
L5-2
L5-3