Meridian Link/Customer Controlled Routing Installation And Upgrade Manual page 408

390 Chapter 14: Software installation, upgrade, and update procedures
553-3202-210 Standard October 1998
Procedure 1: Application configuration and start-up (continued)
Figure 101
Keycode prompt 4
Keycode group 4 (or Q or q to quit):
10 You are prompted for the fourth group of keycode characters. Type
the fourth group and press [Return].
Figure 102
Keycode prompt 5
Keycode group 5 (or Q or q to quit):
11 You are prompted for the fifth group of keycode characters. Type the
fifth group and press [Return].
A list of configured applications appears.
Note: Optional feature prompts will not appear if the features were not
configured in the keycode. For example, if Meridian Link was not
purchased, the prompts in Figures 103, 104, and 105 will not appear.
Figure 103
Meridian Link protocol prompt
Please enter the Meridian Link protocol, x for X.25, <cr> for TCP/IP):
12 If you are activating the Meridian Link application, you are prompted
to enter the Meridian Link protocol.
If you are using the X.25 protocol, type x, press [Return], then go to
step 15.
If you are using the TCP/IP protocol, press [Return], then go to
step 13.