Meridian Link/Customer Controlled Routing Installation And Upgrade Manual page 509

Table 142
X.25 and LAPB parametersÑLink 1 (continued)
Link parameter
Maximum Frame Length*
Baud rate
Fail timer
RFS timer
Internal address
Remote address
T1
Maximum out frames (K)
Note: Parameters marked with an asterisk (*) cannot be changed.
Procedure 14: Changing Meridian Link (link 1) parameters (continued)
Allowed values
(defaults in parentheses)
135
300 600 1200 2400 4800
9600 (19200) 38400
48000 56000 64000
0-(50)Ð9999
0Ð(150)Ð9999
(1), 3
1, (3)
0Ð(20)Ð9999
1Ð(7)
Ñ continued Ñ
Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide
Chapter 15: Link configuration 491
Description
Must be same as baud rate on the
Meridian 1 or host computer config-
uration; if modems are used, must
also match baud rate of the modem
Timer value (in 1/10 second
increments) for monitoring the
signals that indicate link failure
Timer value (in 1/10 second
increments) for monitoring CTS or
DTR signals after line opening
1 for DCE; 3 for DTE
3 for DCE; 1 for DTE. (This value
must be different from the value of
the internal address. The
combination of values for internal
address and remote address must
be the opposite of the values for
the host. That is, if the values for
the host are 3, 1, the values for the
link must be 1, 3.)
Frame recovery time (in 1/10
second increments); must be
identical to the time specified on
the host computer configuration
LAPB window size; must be
identical to the size specified on the
host computer configuration