Wac Port Settings; Wac Authentication State - D-Link Xstack DES-3528 Series Reference Manual

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch Web UI Reference Guide

WAC Port Settings

Users can view and set port configurations for Web authentication.
To view this window, click Security > Web-based Access Control (WAC) > WAC Port Settings, as shown below:
The fields that can be configured are described below:
Parameter
Unit
From Port
To Port
Aging Time (1-1440)
State
Idle Time (1-1440)
Block Time (0-300)
Click the Apply button to accept the changes made.

WAC Authentication State

Users can view and delete the hosts for WAC authentication.
Figure 8-39 WAC Port Settings window
Description
Select the unit to configure.
Use this drop-down menu to select the beginning port of a range of ports to be enabled
as WAC ports.
Use this drop-down menu to select the ending port of a range of ports to be enabled as
WAC ports.
This parameter specifies the time period during which an authenticated host will remain in
the authenticated state. Enter a value between 1and 1440 minutes. Tick the Infinite
check box to indicate the authenticated host will never age out on the port. The default
value is 1440 minutes (24 hours).
Use this drop-down menu to enable the configured ports as WAC ports.
If there is no traffic during the Idle Time parameter, the host will be moved back to the
unauthenticated state. Enter a value between 1 and 1440 minutes. Tick the Infinite check
box to indicate the Idle state of the authenticated host on the port will never be checked.
The default value is infinite.
This parameter is the period of time a host will be blocked if it fails to pass authentication.
Enter a value between 0 and 300 seconds. The default value is 60 seconds.
244