Serial Port Settings; System Log Configuration; System Log Settings - D-Link Xstack DES-3528 Series Reference Manual

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch Web UI Reference Guide
Click Apply to implement changes made. The port status of all PoE configured ports is displayed in the table in the
bottom half of the screen shown above.
Click the Refresh button to update the display section of this page.

Serial Port Settings

This window allows the user to adjust the Baud Rate and the Auto Logout values.
To view the following window, click System Configuration > Serial Port Settings, as shown below:
The fields that can be configured are described below:
Parameter Description
Specify the baud rate for the serial port on the Switch. There are four possible baud rates to
Baud Rate
choose from, 9600, 19200, 38400 and 115200. For a connection to the Switch using the
console port, the baud rate must be set to 115200, which is the default setting.
Select the logout time used for the console interface. This automatically logs the user out
Auto Logout
after an idle period of time, as defined. Choose from the following options: 2, 5, 10, 15
minutes or Never. The default setting is 10 minutes.
Display the data bits used for the serial port connection.
Data Bits
Display the parity bits used for the serial port connection.
Parity Bits
Display the stop bits used for the serial port connection.
Stop Bits
Click the Apply button to implement changes made.

System Log configuration

System Log Settings

The Switch allows users to choose a method for which to save the switch log to the flash memory of the Switch.
Class 1 : 4000mW
Class 2 : 7000mW
Class 3 : 15400mW
User define: 30000mW (15400~30000 only applies to ports 1 - 8)
As well as these four pre-defined settings, users can directly specify any value ranging
from 1000mW to 30000mW on DES-3528P/DES-3552P ports 1 to 8 and 1000mW -
15400mW on DES-3528P ports 9 to 24/DES-3552P ports 9 to 48.
NOTE: DES-3528P/DES-3552P ports 1 to 8 can support PoE up to 30W by configuring
the PoE port user define value, also all ports can support 802.3af (1000 - 15400mW).
Figure 2-16 Serial Port Settings window
23