D-Link Xstack DES-3528 Series Reference Manual page 337

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
Unit
Port
Time Interval
Record Number
ExDefer
CRCError
LateColl
ExColl
SingColl
Collision
Show/Hide
Click the Apply button to accept the changes made for each individual section.
Click the Clear button to clear all statistics counters on this window.
Click the View Table link to display the information in a table rather than a line graph.
Click the View Graphic
Figure 11-13 Transmitted (TX) Table window (for errors)
Description
Select the unit to configure.
Use the drop-down menu to choose the port that will display statistics.
Select the desired setting between 1s and 60s, where "s" stands for seconds. The default
value is one second.
Select number of times the Switch will be polled between 20 and 200. The default value is
200.
Counts the number of packets for which the first transmission attempt on a particular
interface was delayed because the medium was busy.
Counts otherwise valid packets that did not end on a byte (octet) boundary.
Counts the number of times that a collision is detected later than 512 bit-times into the
transmission of a packet.
Excessive Collisions. The number of packets for which transmission failed due to exces-
sive collisions.
Single Collision Frames. The number of successfully transmitted packets for which
transmission is inhibited by more than one collision.
An estimate of the total number of collisions on this network segment.
Check whether or not to display ExDefer, CRCError, LateColl, ExColl, SingColl, and
Collision errors.
link to display the information in a line graph rather than a table.
330