D-Link Xstack DES-3528 Series Reference Manual page 135

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch Web UI Reference Guide
IGMP Multicast VLAN
State
IGMP Multicast VLAN
Forward Unmatched
VLAN Name
VID
Remap Priority
Replace Priority
Click the Apply button to accept the changes made for each individual section.
Click the Add button to add a new entry based on the information entered.
Click the Edit button to configure the IGMP Snooping Multicast VLAN Settings for the specific entry.
Click the Delete button to remove the specific entry.
Click the Profile List link to configure the IGMP Snooping Multicast VLAN Settings for the specific entry.
After clicking the Edit button, the following page will appear:
Figure 4-68 IGMP Snooping Multicast VLAN Settings – Edit window
The fields that can be configured are described below:
Parameter
State
Replace Source IP
Click the radio buttons to enable or disable the IGMP Multicast VLAN state.
Click the radio buttons to enable or disable the IGMP Multicast VLAN Forwarding
state.
Enter the VLAN Name used.
Enter the VID used.
0-7 – The remap priority value (0 to 7) to be associated with the data traffic to be
forwarded on the multicast VLAN.
None – If None is specified, the packet's original priority is used. The default setting is
None.
Specify that the packet's priority will be changed by the Switch, based on the remap
priority. This flag will only take effect when the remap priority is set.
Description
Use the drop-down menu to enable or disable the state.
With the IGMP snooping function, the IGMP report packet sent by the host will be
forwarded to the source port. Before forwarding of the packet, the source IP address
in the join packet needs to be replaced by this IP address. If none is specified, the
source IP address will not be replaced.
128