Authenticator State - D-Link Xstack DES-3528 Series Reference Manual

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch Web UI Reference Guide
access. The adjacent figure should give the user a better understanding of the Guest VLAN process.
Limitations Using the Guest VLAN
1. Ports supporting Guest VLANs cannot be GVRP enabled and vice versa.
2. A port cannot be a member of a Guest VLAN and a static VLAN simultaneously.
3. Once a client has been accepted into the target VLAN, it can no longer access the Guest VLAN.
Remember, to set an 802.1X guest VLAN, the user must first configure a normal VLAN, which can be enabled here
for guest VLAN status. Only one VLAN may be assigned as the 802.1X guest VLAN.
To view this window, click Security > 802.1X > Guest VLAN Settings, as shown below:
The fields that can be configured are described below:
Parameter Description
Enter the pre-configured VLAN name to create as an 802.1X guest VLAN.
VLAN Name
Use the drop-down menu to select a unit to configure.
Unit
Set the ports to be enabled for the 802.1X guest VLAN. Click the All button to select all the ports.
Port
Click the Apply button to accept the changes made.
Click the Delete button to remove the specific entry based on the information entered.

Authenticator State

The following section describes the 802.1X Authenticator State on the Switch. This window displays the
Authenticator State for individual ports on a selected device. In Port-based mode if one of the attached hosts is
successfully authorized, all hosts on the same port will be granted access to the network. If the port authorization
fails, the specified port(s) will continue authenticating. In Host-based mode each user can individually authenticate
and access the network.
To view this window, click Security > 802.1X > Authenticator State, as shown below:
Figure 8-13 Guest VLAN Settings window
Figure 8-14 Authenticator State window
220