xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch Web UI Reference Guide
To view this window, click Monitoring > Mirror > RSPAN Settings, as shown below:
The fields that can be configured are described below:
Parameter
RSPAN State
VLAN Name
VID
Click the Apply button to accept the changes made.
Click the Add button to add a new entry based on the information entered.
Click the Modify button to re-configure the specific entry.
Click the Delete button to remove the specific entry.
After clicking the Modify button, the following page will appear:
The fields that can be configured are described below:
Parameter
VID
VLAN Name
Source Ports
Redirect Port List
Figure 11-17 RSPAN Settings window
Description
Click the radio buttons to enable or disable the RSPAN feature.
Create the RSPAN VLAN by VLAN name.
Create the RSPAN VLAN by VLAN ID.
Figure 11-18 RSPAN Settings – Modify window
Description
Displays the RSPAN VLAN by VLAN ID.
Displays the RSPAN VLAN by VLAN name.
If the ports are not specified by option, the source of RSPAN will come from the source
specified by the mirror command or the flow-based source specified by an ACL. If no
parameter is specified for Source, it deletes the configured source parameters.
Select RX, TX or Both to specify in which direction the packets will be monitored. Tick
Add or Delete to add or delete source ports.
Specify the output port list for the RSPAN VLAN packets. If the redirect port is a Link
Aggregation port, the Link Aggregation behavior will apply to the RSPAN packets. Tick
335