D-Link Xstack DES-3528 Series Reference Manual page 200

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
Access ID (1-128)
Chunk
Action
Priority (0-7)
Replace Priority
Figure 7-21 Add Access Rule (Packet Content ACL)
Description
Type in a unique identifier number for this access. This value can be set from 1 to
128. Tick the Auto Assign check box to instruct the Switch to automatically assign an
Access ID for the rule being created.
Tick the check box and enter the chunk value.
Select Permit to specify that the packets that match the access profile are forwarded
by the Switch, according to any additional rule added (see below).
Select Deny to specify that the packets that match the access profile are not
forwarded by the Switch and will be filtered.
Select Mirror to specify that packets that match the access profile are mirrored to a
port defined in the config mirror port command. Port Mirroring must be enabled and a
target port must be set.
Tick the corresponding check box if you want to re-write the 802.1p default priority of
a packet to the value entered in the Priority field, which meets the criteria specified
previously in this command, before forwarding it on to the specified CoS queue.
Otherwise, a packet will have its incoming 802.1p user priority re-written to its
original value before being forwarded by the Switch.
For more information on priority queues, CoS queues and mapping for 802.1p, see
the QoS section of this manual.
Tick this check box to replace the Priority value in the adjacent field.
193