Ethernet Port Connector Pinout Information For An Ex9200 Switch; Table 51: Ethernet Port Connector Pinout Information For Ex9200 Switches - Juniper EX9214 Hardware Manual

Ethernet Port Connector Pinout Information for an EX9200 Switch

Related
Documentation
Copyright © 2015, Juniper Networks, Inc.
Front Panel of an EX4500 Switch
Management Panel of an EX4600 Switch
EX4550 Switches Hardware Overview
Switch Fabric and Routing Engine (SRE) Module in an EX6200 Switch
Switch Fabric and Routing Engine (SRE) Module in an EX8208 Switch
Routing Engine (RE) Module in an EX8216 Switch
Routing Engine Module in an EX9200 Switch on page 27
Booting an EX Series Switch Using a Software Package Stored on a USB Flash Drive
The Ethernet ( ) port on an EX9200 switch uses an RJ-45 connector to connect to a
<...>
management device for out-of-band management.
The port uses an autosensing RJ-45 connector to support a 10/100-Mbps Ethernet
connection. Two LEDs on the port indicate link activity on the port and the administrative
status of the port.
Table 51 on page 121 provides the pinout information of the RJ-45 connector. An RJ-45
cable, with a connector attached, is supplied with the switch.
Table 51: Ethernet Port Connector Pinout Information for EX9200
Switches
Pin Signal
1 TX+
2 TX–
3 RX+
4 Termination network
5 Termination network
6 RX–
7 Termination network
8 Termination network
Connecting an EX9200 Switch to a Network for Out-of-Band Management on page 157
Routing Engine Module in an EX9200 Switch on page 27
Chapter 9: Pinout Specifications
121