Usb Port Specifications For An Ex Series Switch - Juniper EX9214 Hardware Manual

EX9214 Switch Hardware Guide
Related
Documentation

USB Port Specifications for an EX Series Switch

Related
Documentation
120
Table 50: EX9200 Switches Console Port and AUX Port Connector Pinout
Information (continued)
Pin Signal
7 DSR/DCD
8 CTS
Connecting an EX9200 Switch to a Management Console or an Auxiliary Device on
page 158
Routing Engine Module in an EX9200 Switch on page 27
The following Juniper Networks USB flash drives have been tested and are officially
supported for the USB port on all EX Series switches:
RE-USB-1G-S
RE-USB-2G-S
RE-USB-4G-S
CAUTION: Any USB memory product not listed as supported for EX Series
switches has not been tested by Juniper Networks. The use of any
unsupported USB memory product could expose your EX Series switch to
unpredictable behavior. Juniper Networks Technical Assistance Center (JTAC)
can provide only limited support for issues related to unsupported hardware.
We strongly recommend that you use only supported USB flash drives.
All USB flash drives used on EX Series switches must have the following features:
USB 2.0 or later.
Formatted with a FAT or MS-DOS file system.
If the switch is running Junos OS Release 9.5 or earlier, the formatting method must
use a master boot record. Microsoft Windows formatting, by default, does not use a
master boot record. See the documentation for your USB flash drive for information
about how your USB flash drive is formatted.
EX2200 Switches Hardware Overview
Rear Panel of an EX3200 Switch
Rear Panel of an EX3300 Switch
Rear Panel of an EX4200 Switch
EX4300 Switches Hardware Overview
Description
Data set ready
Clear to send
Copyright © 2015, Juniper Networks, Inc.