Transceiver And Cable Specifications; Pluggable Transceivers Supported On Ex9200 Switches - Juniper EX9214 Hardware Manual

CHAPTER 8

Transceiver and Cable Specifications

Pluggable Transceivers Supported on EX9200 Switches

Copyright © 2015, Juniper Networks, Inc.
Pluggable Transceivers Supported on EX9200 Switches on page 87
SFP+ Direct Attach Cables for EX Series Switches on page 111
Cables Connecting the EX9200 Switch to Management Devices on page 115
Understanding EX Series Switches Fiber-Optic Cable Signal Loss, Attenuation, and
Dispersion on page 116
The linecards in EX9200 switches support SFP, SFP+, QSFP+, and CFP transceivers.
This topic describes the optical interfaces supported for those transceivers.
NOTE: We recommend that you use only optical transceivers and optical
connectors purchased from Juniper Networks with your Juniper Networks
device.
CAUTION: If you are having a problem running a Juniper Networks device
that is using a third-party optic or cable, the Juniper Networks Technical
Assistance Center (JTAC) can help you diagnose the source of the problem.
Your JTAC engineer might recommend that you check the third-party optic
or cable and potentially replace it with an equivalent Juniper Networks optic
or cable that is qualified for the device.
The Gigabit Ethernet SFP, SFP+, and QSFP+transceivers and 100GBASE-LR4 CFP
transceiver installed in EX9200 switches support digital optical monitoring (DOM): You
can view the diagnostic details for these transceivers by issuing the operational mode
CLI command
show interfaces diagnostics optics
The tables in this topic describe the optical interface support over single-mode fiber-optic
(SMF) and multimode fiber-optic (MMF) cables for SFP, SFP+, QSFP+, and CFP
transceivers:
Table 43 on page 88—Optical interface support for SFP transceivers.
Table 44 on page 102—Optical interface support for SFP+ transceivers.
.
87