Figure 68: Removing A Line Card From An Ex9200 Switch - Juniper EX9214 Hardware Manual

EX9214 Switch Hardware Guide
Related
Documentation
214
CAUTION: After removing a line card, wait for at least 30 seconds before
installing a line card or removing another line card.
If you are not installing a line card in the emptied line card slot within a short time,
8.
install a cover panel over the slot. Do this to protect the interior of the chassis from
dust or other foreign substances and to ensure that the airflow inside the chassis is
not disrupted.
Figure 68 on page 214 shows removing a line card from an EX9204 switch. The procedure
and orientation of the line card are the same for EX9208. The procedure is the same for
EX9214 switch; however, the orientation of the line cards is different—it is installed
vertically into the top and bottom of the chassis.

Figure 68: Removing a Line Card from an EX9200 Switch

Line card
Ejectors
Installing a Line Card in an EX9200 Switch on page 210
EX9204 Switch Hardware Overview
EX9208 Switch Hardware Overview
EX9214 Switch Hardware Overview on page 3
Copyright © 2015, Juniper Networks, Inc.