Routing Engine Module Leds In An Ex9200 Switch; Table 16: Network Port Leds On Line Cards In An Ex9200 Switch-Status; Table 17: Re Module Leds Of An Ex9200 Switch - Juniper EX9214 Hardware Manual

EX9214 Switch Hardware Guide
Related
Documentation

Routing Engine Module LEDs in an EX9200 Switch

34
Table 16: Network Port LEDs on Line Cards in an EX9200 Switch—Status
LED
LED LCD Indicator
Status LED: ADM
LED: SPD
LED: DPX
Line Card LED in an EX9200 Switch on page 59
Craft Interface in an EX9200 Switch on page 20
Each Routing Engine module (RE module) has four LEDs on the module faceplate.
Table 17 on page 34 describes the functions of these LEDs.

Table 17: RE Module LEDs of an EX9200 Switch

LED Label Status
Blue
MASTER
Unlit
STORAGE Green
Green
ONLINE
Red
OK/FAIL
State, Color, and Description
Indicates the administrative status (enabled or
disabled). The status indicators are:
Green—Administrative status enabled.
Yellow—The port is down.
Unlit—Administrative status disabled.
Indicates the speed. The speed indicators are
different in the line cards.
Unlit—10 Mbps
Green—Blinking—100 Mbps
Green—On steadily—1000 Mbps
Indicates the duplex mode. The status
indicators are:
Green—Port is set to full-duplex mode.
Unlit—Port is not set to full-duplex mode.
State and Description
Routing Engine is functioning as the master.
Routing Engine is either functioning as the backup
or not installed.
Blinking—Indicates activity on the solid-state drive
(SSD) or the flash memory device.
On steadily—Routing Engine is operating
normally.
Blinking—Routing Engine is coming online or
going offline.
Routing Engine has failed.
Copyright © 2015, Juniper Networks, Inc.