Table 48: SFP+ Direct Attach Cable Specifications (continued)
Model Number
EX-SFP-10GE-DAC-7M
Standards Supported by These Cables
Related
Documentation
Cables Connecting the EX9200 Switch to Management Devices
Copyright © 2015, Juniper Networks, Inc.
Specification
Rate
Connector type
Supply voltage
Power consumption (per end)
Storage temperature
Cable type
Wire AWG
Minimum cable bend radius
Cable characteristic impedance
Crosstalk between pairs
Time delay
Length
The cables comply with the following standards:
SFP mechanical standard SFF-843—see
Electrical interface standard SFF-8432—see
SFP+ Multi-Source Alliance (MSA) standards.
Pluggable Transceivers Supported on EX Series Switches
Installing a Transceiver in an EX Series Switch on page 215
Removing a Transceiver from a Switch on page 217
Table 49 on page 116
lists the specifications for the cables that connect the Routing
Engine in an EX9200 switch to a management device.
Chapter 8: Transceiver and Cable Specifications
Value
10-Gbps full-duplex serial transmission
SFP+ passive Twinax cable assembly
3.3 V
0.57 W
°
°
–40
C through 85
C
Twinax
24 AWG
1 in. (2.54 cm)
100 ohms
2% maximum
1.31 nsec/ft
23 ft (7 m)
ftp://ftp.seagate.com/sff/SFF-8431.PDF
ftp://ftp.seagate.com/sff/SFF-8432.PDF
.
.
115