Figure 58: Removing A Dc Power Supply From An Ex9214 Switch - Juniper EX9214 Hardware Manual

EX9214 Switch Hardware Guide
Related
Documentation
190

Figure 58: Removing a DC Power Supply from an EX9214 Switch

Let go of the locking pin in the release lever. Ensure that it is seated in the corresponding
11.
hole in the chassis.
WARNING: Do not touch the connector on the top of the power supply.
Pull the power supply straight out of the chassis.
12.
Installing a DC Power Supply in an EX9214 Switch on page 185
DC Power Supply in an EX9214 Switch on page 43
Copyright © 2015, Juniper Networks, Inc.