Connecting And Configuring An Ex9200 Switch (Cli Procedure) - Juniper EX9214 Hardware Manual

EX9214 Switch Hardware Guide
Related
Documentation

Connecting and Configuring an EX9200 Switch (CLI Procedure)

164
Configuration Files Terms
Connecting and Configuring an EX Series Switch (CLI Procedure)
Connecting and Configuring an EX Series Switch (J-Web Procedure)
Connecting and Configuring an EX9200 Switch (CLI Procedure) on page 164
Understanding Configuration Files for EX Series Switches
EX9204 Switch Hardware Overview
EX9208 Switch Hardware Overview
EX9214 Switch Hardware Overview on page 3
The EX9200 switch is shipped with the Junos OS preinstalled and ready to be configured
when the switch is powered on. There are three copies of the software: one on a
CompactFlash card in the Routing Engine module (RE module), one on a rotating hard
disk in the RE module, and one on a USB flash drive that can be inserted into the slot in
the faceplate of the RE module.
When the switch boots, it first attempts to start the image on the USB flash drive. If there
is no USB flash drive inserted into the RE module or if the attempt otherwise fails, the
switch next attempts to start the software from the CompactFlash card (if installed),
and finally from the hard disk.
You configure the switch by issuing Junos OS command-line interface (CLI) commands,
either on a console device attached to the console (
module, or over a telnet connection to a network connected to the Ethernet management
( ) port on the master RE module.
<...>
Gather the following information before configuring the switch:
Name the switch will use on the network
Domain name the switch will use
IP address and prefix length information for the Ethernet interface
IP address of a default switch
IP address of a DNS server
Password for the root user
) port on the master RE
CONSOLE
Copyright © 2015, Juniper Networks, Inc.