Removing A Transceiver From A Switch; Figure 69: Installing A Transceiver In An Ex Series Switch - Juniper EX9214 Hardware Manual

Related
Documentation

Removing a Transceiver from a Switch

Copyright © 2015, Juniper Networks, Inc.

Figure 69: Installing a Transceiver in an EX Series Switch

1— Ejector lever
Removing a Transceiver from a Switch on page 217
Connecting a Fiber-Optic Cable to a Switch on page 161
Pluggable Transceivers Supported on EX Series Switches
The transceivers for EX Series switches and OCX1100 switches are hot-removable and
hot-insertable field-replaceable units (FRUs): You can remove and replace them without
powering off the switch or disrupting switch functions.
NOTE: After you remove a transceiver or when you change the media-type
configuration, wait for 6 seconds for the interface to display the operational
commands.
Before you begin removing a transceiver from a switch, ensure that you have taken the
necessary precautions for safe handling of lasers (see
and Warnings for Switches" on page
Ensure that you have the following parts and tools available:
An antistatic bag or an antistatic mat
Rubber safety caps to cover the transceiver and fiber-optic cable connector
A dust cover to cover the port
Figure 70 on page 219 shows how to remove a QSFP+ transceiver. The procedure is the
same for all types of transceivers except the CFP transceivers.
To remove a transceiver from a switch:
Place the antistatic bag or antistatic mat on a flat, stable surface.
1.
Label the cable connected to the transceiver so that you can reconnect it correctly.
2.
Chapter 21: Replacing Transceiver
"Laser and LED Safety Guidelines
292).
217