Installing A Dc Power Supply In An Ex9214 Switch; Figure 56: Removing An Ac Power Supply From An Ex9214 Switch - Juniper EX9214 Hardware Manual

Related
Documentation

Installing a DC Power Supply in an EX9214 Switch

Copyright © 2015, Juniper Networks, Inc.

Figure 56: Removing an AC Power Supply from an EX9214 Switch

Let go of the locking pin in the release lever. Ensure that it is seated in the corresponding
6.
hole in the chassis.
WARNING: Do not touch the connector on the top of the power supply.
Gently pull the power supply out of the chassis.
7.
Installing an AC Power Supply in an EX9214 Switch on page 181
AC Power Supply in an EX9214 Switch on page 39
The DC power supply in an EX9214 switch is a hot-insertable and hot-removable
field-replaceable unit (FRU) installed in the rear panel. Up to four DC power supplies can
be installed in an EX9214 switch.
Before you install a DC power supply in the switch:
Chapter 17: Replacing Power Supply
185