Unpacking The Switch; Unpacking The Ex9200 Switch - Juniper EX9214 Hardware Manual

CHAPTER 10

Unpacking the Switch

Unpacking the EX9200 Switch

Copyright © 2015, Juniper Networks, Inc.
Unpacking the EX9200 Switch on page 125
Unpacking a Line Card Used in an EX9200 Switch on page 126
Parts Inventory (Packing List) for an EX9214 Switch on page 127
Registering Products–Mandatory for Validating SLAs on page 130
The switch is shipped in a wooden crate. A wooden pallet forms the base of the crate.
The switch chassis is bolted to this pallet. Quick start installation instructions and a
cardboard accessory box are also included in the shipping crate.
NOTE: The switch is maximally protected inside the shipping box. Do not
unpack it until you are ready to begin installation.
Ensure that you have the following parts and tools available:
Phillips (+) screwdrivers, number 1 and 2
1/2-in. or 13-mm open-end or socket wrench to remove bracket bolts from the shipping
pallet
Cover panels to cover any slots not occupied by a component
To unpack the switch:
Move the shipping crate to a staging area as close to the installation site as possible,
1.
where you have enough room to remove the components from the chassis. While the
chassis is bolted to the pallet, you can use a forklift or pallet jack to move it.
Position the shipping crate with the arrows pointing up.
2.
Open all the latches on the shipping crate.
3.
Remove the front door of the shipping crate cover and set it aside.
4.
Slide the remainder of the shipping crate cover off the pallet.
5.
Remove the foam covering the top of the switch.
6.
125