Copyright © 2015, Juniper Networks, Inc.
Figure 57: Installing a DC Power Supply in an EX9214 Switch
While firmly pushing the handle of the power supply with one hand, use the other
7.
hand to pull the spring-loaded locking pin in the release lever away from the chassis
and turn the release lever in the clockwise direction until it stops.
Let go of the locking pin in the release lever. Ensure that it is seated in the corresponding
8.
hole in the chassis.
NOTE:
If you have a Juniper J-Care service contract, register any addition,
change, or upgrade of hardware components at
https://www.juniper.net/customers/support/tools/updateinstallbase/
to do so can result in significant delays if you need replacement parts. This
note does not apply if you replace existing components with the same type
of component.
To connect power to a DC power supply, see
on page
149.
Chapter 17: Replacing Power Supply
"Connecting DC Power to an EX9214 Switch"
. Failure
187