Switch Fabric Module Leds In An Ex9200 Switch; Cable Management Bracket In An Ex9214 Switch; Table 18: Sf Module Leds Of An Ex9200 Switch - Juniper EX9214 Hardware Manual

Related
Documentation

Switch Fabric Module LEDs in an EX9200 Switch

Related
Documentation

Cable Management Bracket in an EX9214 Switch

Copyright © 2015, Juniper Networks, Inc.
Switch Fabric Module in an EX9200 Switch on page 29
Installing an RE Module in an EX9200 Switch on page 191
Removing an RE Module from an EX9200 Switch on page 193
The Switch Fabric module (SF module) has three LEDs on the module faceplate.
Table 18 on page 35 describes the functions of these LEDs.

Table 18: SF Module LEDs of an EX9200 Switch

LED Status
FABRIC ACTIVE Green
Unlit
Green
FABRIC ONLY
Unlit
Green
OK/FAIL
Red
Unlit
The , , and LEDs, located next to the
BITS GPS UTI
respective clocking interface. These LEDs are not supported.
Installing an SF Module in an EX9200 Switch on page 200
Removing an SF Module from an EX9200 Switch on page 203
Taking the Host Subsystem Offline in an EX9200 Switch on page 194
The cable management bracket (see
dividers for securing the cables connected to the line cards and Switch Fabric modules
(SF modules). It is located below the line card and SF module slots. You can use cable
strips or other ties to gently secure the cables to the cable management bracket.
Chapter 2: Chassis Components and Descriptions
Description
Switch Fabric is in active mode.
Switch Fabric is offline.
On steadily—Switch Fabric is operating in
fabric-only mode.
Switch Fabric is not operating in fabric-only mode.
Switch Fabric is online.
Switch Fabric has failed.
Switch Fabric is offline.
port, indicate the status of the
EXT CLK
Figure 17 on page 36) consists of a tray with fourteen
35